3M Textured Surface Applicator TSA-1, For Large Surfaces, 1 each

3M™ Textured Surface Applicator TSA-1, For Large Surfaces
Details

Heat resistant foam roller.

Before using this tool, read and following these important notes, cautions and warnings to ensure personal and mechanical safety.

Use with a high temperature, electronically-controlled heat gun and 3M recommended films.

Application tool designed specifically for conforming large areas of selected films to textured surfaces. 3M Textured Surface Applicator TSA-1 Use for conforming large areas of film onto a textured surface.
1. Wear a heat-resistant glove on the hand that holds applicator TSA-1.
2. Gently tack the top few inches of the film to the substrate. Use tapping motion with your fingers or lightly roll it, without heat, using applicator TSA-1.
3. Set the heat gun to the temperature specified in Instruction Bulletin 5.37. To set edges, quickly and lightly pass the TSA-1 tool and the heat gun over the edges of the film to set the edges, but do not seal or conform the film; it is critical that air have an escape path during installation. This is especially recommended when using overlaminate 8524.
4. Direct the heat gun toward the top corner of the graphic. Heat the film until warm, which usually takes only about 2 seconds and immediately begin rolling the film with the applicator TSA-1. Notice that the roller is positioned about 2 inches above the top edge of the graphic for the first pass.
5. With the applicator closely following the heat gun, move continuously at about 2 inches per second and completely past the outer open edge of the graphic.

Returns Not Accepted